Level 2 1.7.3.2 Import into SYS08 SKU Details module

Hi Folks,

I am facing error in Distribution center Mapping.

attached is my model view.

 

Please guide .

Comments

  • Hey,

     

    can you please share blue print view of the module? I can see a subsidiary view (line item applies to not matching with module applies to) on Distribution center line item.

     

    Thanks & Regards,

    Sai Bharadwaj

    https://www.linkedin.com/in/sai-bharadwaj-venati/

    V.Sai Bharadwaj

    Connect on LinkedIn

  • @Abhishek90 

    anandshekhawat_0-1651234038364.png

     

    There is a subsidiary view set for Distribution Centre Line Item. Kindy make sure that the dimension that you have applied to the module is also applicable to this particular Line item. Once done, try to re import the data.

    You will get it updated correctly.

     

    ~Anand

     

    https://in.linkedin.com/in/anand-shekhawat-35645486

  • Hi Buddy,

    Attached screen shot for your ref.

  • Hi @Abhishek90 

    There are two potential issues you'd need to address:

    1. I see your Distribution Center format is set to No Data - this is basically telling Anaplan that you don't want to use this line item for any data/compuation. If you are hoping to import a list here, you need to set the format right. 
    2. Do check the dimension as highlighted by others too - all the import line items should have P3 SKU as their dimension. Anaplan assigns a '-' when the line item dimension is same as the module dimension. In your case, the '-' is missing in the Distribution Center line item. Either manually select P3 SKU there or just copy/past/type a '-'
  • Thank you so much Ankit for your guidance

    It works perfectly fine for me.

     

    Regards

    Abhishek

  • @anand.shekhawat

    I can only see "supplied by" column in target module as against "distribution center" in source module. While I have mapped the two and it did populate the data but I'm quite unsure if its correctly reflecting here…

  • @PreetiJain

    It might be a possibility that Anaplan has made some tweaks in the present training modules. As per the old certification training lessons I would expect 'Distribution Center' in place of 'Supplied By' in the above SYS08 Module. But it would not make any difference in the working of the model. It should work absolutely fine.

    I would still recommend you to go through the training lessons once again to find out if you were asked to create 'Supplied By' line item and not 'Distribution Centre'. I am asking this because it might create a bit of confusion going forward and can cause trouble while taking your certification exam.

    If you find that 'Supplied By' is the correct line item that should be there, then I don't think there should be any problem.

    Please let me know if it helps.

    ~Anand

    https://in.linkedin.com/in/anand-shekhawat-35645486

  • Thanks @anand.shekhawat

    Yes, 'Supplied By' is the correct line item in my case.

  • That's Great @PreetiJain

    It should not be a problem then.

    Happy Anaplanning!

    ~Anand

    https://in.linkedin.com/in/anand-shekhawat-35645486