Hi all,
This is not working for me(The employee Details).
I have selected various combinations for mapping but report not coming right.
Guide me on the correct details to map please from the attached.
Thanks in anticipation!
Regards,
Eboseremen
Solved! Go to Solution.
Alright, lets make the following:
Points 1 and 2 perhaps are not really needed in your case, but is better to err on the side of caution and I would recommend you to double check them anyways. Now:
After following these steps, I do not think you will run into new errors.
Hi, "Sys08 employee details" in target should be mapped to "column headers" instead of to "column1: employees". Then, on the third of the three tabs on the upper part of the mapping window, make surs that each of the column headers is correctly mapped to the line items of your target module.
Cheers
Alex
Thanks Alex,
I have mapped code E2 and Column header for SYS08 details.
The result still shows errors in the dats.
See attached.
Regards,
Eboseremen
Could you please attach a pic of the mapping you have used in the line item tab? Here:
Thanks
Hi Alex,
See attached as requested.
Regards,
Eboseremen
Alright, lets make the following:
Points 1 and 2 perhaps are not really needed in your case, but is better to err on the side of caution and I would recommend you to double check them anyways. Now:
After following these steps, I do not think you will run into new errors.
Thanks Alex for your detailed feedback.
It worked for me. See attached the report