LEVEL 2 SPRINT 2 format issues

Younes
Contributor

LEVEL 2 SPRINT 2 format issues

Hello

I have a format problem in this module. Instead of having 58.88 for example like @Lkishko , i have 5,887,728... like shown below :

Younes_0-1591190513807.png

Insted of having this format : 

Younes_1-1591190561278.png

Any help ?

Thanks

Younes

2 ACCEPTED SOLUTIONS

Accepted Solutions
Tiffany.Rice
Certified Master Anaplanner

Re: LEVEL 2 SPRINT 2 format issues

@Younes 

 

In case you missed my response on the other thread.  The issue at hand is with the import action where data was loaded into DAT03 Historic Volumes.  It appears to me that the decimal separator was set to Comma rather than Dot and thus the volumes that were loaded did not correctly pick up the decimal point.  Try reloading the Historic+Volumes.csv file.

 

https://community.anaplan.com/t5/Anaplan-Platform/Level-2-MB-Sprint-2-Verify-DEM03-Formulas-amp-Summ...

View solution in original post

prabhu
Community Boss

Re: LEVEL 2 SPRINT 2 format issues

Hi @Younes - Change the format of Volumes line item in DAT03 Historic Volumes Module.

 

Capture13.JPG

Sorna Raja Prabhu

View solution in original post

4 REPLIES 4
prabhu
Community Boss

Re: LEVEL 2 SPRINT 2 format issues

Hi @Younes - Change the format.

 

Capture11.JPG

 

 

 

I Think you should change for Baseline forecast as well.

 

Thanks,

Sorna Raja Prabhu
Younes
Contributor

Re: LEVEL 2 SPRINT 2 format issues

Hello @prabhu 

Thnaks for you response. It's already my format : 

Younes_0-1591192911099.png

 

prabhu
Community Boss

Re: LEVEL 2 SPRINT 2 format issues

Hi @Younes - Change the format of Volumes line item in DAT03 Historic Volumes Module.

 

Capture13.JPG

Sorna Raja Prabhu

View solution in original post

Tiffany.Rice
Certified Master Anaplanner

Re: LEVEL 2 SPRINT 2 format issues

@Younes 

 

In case you missed my response on the other thread.  The issue at hand is with the import action where data was loaded into DAT03 Historic Volumes.  It appears to me that the decimal separator was set to Comma rather than Dot and thus the volumes that were loaded did not correctly pick up the decimal point.  Try reloading the Historic+Volumes.csv file.

 

https://community.anaplan.com/t5/Anaplan-Platform/Level-2-MB-Sprint-2-Verify-DEM03-Formulas-amp-Summ...

View solution in original post