Stuck in Level 2 - Sprint 1 - Lesson 1.5.6.1 and 1.5.7.1 - Add Category

Highlighted
Occasional Contributor

Stuck in Level 2 - Sprint 1 - Lesson 1.5.6.1 and 1.5.7.1 - Add Category

Hi

 

Can someone shed some light on selecting the CATEGORY in the Functional area Tab?  The lesson requires us to assign (Screenshot attached) functional area and CATEGORY.  I was able to to do the functional area but not the CATEGORY.  The drop down list in the CATEGORY (screenshot attached) does not have the options required.  I tried unsuccessfully to add a new 'CATEGORY'.  I have referred to all the community discussion but still find it difficult to correctly identify the answer.  Where do I go to add a NEW CATEGORY? I referred to Anapedia but again unsuccessful in understanding this.

Some help will be greatly appreciated.  Screenshot (167).pngScreenshot (168).pngScreenshot (169).png

1 REPLY 1
Highlighted
Frequent Contributor

Re: Stuck in Level 2 - Sprint 1 - Lesson 1.5.6.1 and 1.5.7.1 - Add Category

Hi @ThiruT 

 

Here the category means categorizing the modules as System Modules and Data modules . As we can see in the modules section we have done during the earlier steps categorized as DATA MODULES and SYSTEM MODULES and so on . 

 

That will do the trick . Keeping Dat modules under DATA MODULES and SYS modules under SYSTEM Modules . Keep this modules as No data format and Give Heading Style as well . 

 

Thanks,

Puneeth HP