Is there a way to identify Source Items in a list that have not been mapped to an item in the target for a Upload to a module in Grid Mode?
I am aware you can manually identify the non-mapped items by scanning the Mapping tab but this seems inefficient and error prone (especially with large data sets). When you upload with a non-mapped item no error is recorded and hence it is difficult to identify
My example is below is only using a small data set but displays my question
It's not currently an issue for me but was just thinking about how you could confirm completeness of uploads with large data sets. I could definitely see scenarios where 1 or multiple Source items are slightly different to the Target etc and it would be difficult to determine whether the full data set has been imported
You could always create Dummy list item in the data source which is the SUM of all the other list items the source. You could then create a module with this item mapped through and compare vs the results from the upload module to identify variances
Think it would be helpful for Anaplan to have a native solution for this because it doesn't matter how fantastic the calculation engine is if the source data is incorrect!
But until then, I would follow what @JaredDolich has explained. When you need a robust data integration, then you would build staging modules and landing modules. The unmapped entities would remain in the staging module and validated items would land in the landing/target module. This way the user/admin can know which data items dint make their way into Anaplan.
Re: Upload - Non Mapped Source Items Identification
Similar to what all of you have mentioned, what we did was to load the file to a flat staging module and create a reconciliation module which is by time and line items only. In the staging module, we create line item that uses FINDITEM to identify the possibly unmapped list items for each list, and create module view with filter to show the unmapped items only. The reconciliation module summarizes data in the staging module and target module such as total value in source file (staging module), total value in target module, total value of unmapped items of each list. When administrator notices that there is unmapped value in the reconciliation module, further investigation is done via module views in the staging module.