7.2.3

mwoodsmall

I'm stuck trying to map this import. Below is an image of how I was trying to map it. If anyone knows how to map this correctly I would appreciate it.

 

jagadishdash

@mwoodsmall 

Hey, You created the model dimension wrong. There's no time dimensions in SYS08 module.

SO create the SYS08 module with only #E2 employee dimension remove the Time.

Then import and map the other two as you did correct. there'll be no time mapping.

 

Hope it helps.

 

Thanks,

Jagadish Dash

mwoodsmall

Hi @jagadishdash ,

 

Thanks for your response. I have removed the time mapping and left the other two as I did in the original picture. However, when I run the import, I'm getting this error below:

Any help on this is appreciated!

jagadishdash

@mwoodsmall 

Please share your module screenshot, mapping screenshot and error screenshot. 

To know where you're going wrong. 

 

Thanks, 

mwoodsmall

Here is the target mapping page:

And here is the mapping tab so that the date reads MMDDYYYY:

The error I'm getting is the one shown in my previous response.

 

Thank you

 

jagadishdash

@mwoodsmall 

No, your mapping should be YYYYDDMM

You can see in the right side you need to map like that. YearDateMonth 

 

Thanks, 

 

Jagadish Dash

mwoodsmall

@jagadishdash 

 

I am still getting this error even after correcting the date format.

 

jagadishdash

Please share your module screenshot. 

mwoodsmall

@jagadishdash 

Here are screenshots of the whole process:

 

 

 

 

Thanks

 

jagadishdash

@mwoodsmall 

You mistake in module creation. You took wrong dimension as department. You need to take the dimension of #E2 employee list. 

 

mwoodsmall

@jagadishdash 

 

I'm not sure what you mean.

 

 

jagadishdash

@mwoodsmall 

As i can see your module screenshot you took module dimension as Department. But for SYS08 Employee Details module you need to take dimension as E2 Employee. so change the dimension to E2 employee and do the import process.

see the below pic. applies to should be E2 employee. You see your blueprint view its department. so just click that applies to 3 dot and change it to E2 employee and then go for import.

 

Hope now you got, where you did mistake !

 

Thanks,

 

Jagadish Dash

 

mwoodsmall

@jagadishdash 

 

So after changing that dimension to E2 Employee, I'm still getting this error message below: