Is there a way to retrieve two or three Anaplan reports to one excel add-in tab? I tried but it jumped to a new tab. Thanks.
Hi @vicky
I believe you can only retrieve one module/view into one excel tab at a time. I assume that you're trying to create a view in excel that combines multiple modules? One way to accomplish this would be to have separate excel tabs for each Anaplan module and then create another "Dashboard" tab that uses excel formulas that refer to each of the module tabs.
This way, you could open the spreadsheet and just refresh the Anaplan module tabs and the resulting excel report tab would pull the refreshed values.
Hopefully, this helps!
If we schedule two CloudWorks actions to start at the same time, using the same source model but different saved views, and updates two different target models, will they run in parallel or sequentially (with one finishing before the other starts)?
Just like the main question above, I wanted to try out the new feature on the board where you can you the insights panel to put additional cards. However, I wanted to synchronize scroll a card on the main board with the card on the insights panel but I can't find where it might be.
Hi everyone, I am trying to create a connection ADO from PostgreSQL, but I consistently receive the following error: Failed to establish a connection The following message was sent from the target system: The SSL certificate is either invalid or not in unencrypted PEM format. Please check your certificate and try again.…
