I have got this error message however I tried to do it. I am not sure where I am going wrong. I followed the Anaplan community replies thread but am unable to follow. Obviously this is why I am still getting the error message. Some help will be greatly appreciated. I have attached screen shots of the DATA HUB Model IMPORTS tab as well as IMPORT DATA SOURCES Tab. I have also attached the error message I am getting. I do notice that the Source Model name is different to the name I have created. Is this a problem?
(1) Is the process run to draw data from DATA01 Historic Volumes, DAT02 Shipping metrics, DAT03 Historic Volumes? from the Data Hub Model? These data modules seem to already exist in the supply chain model. Screen shot attached
Or Is the lesson referring to Saved Views? I thought this may be the case and I mapped individual action to the the individual saved views. This may be wrong. Message attached.
(2) My next question is Lesson 188.8.131.52 says run process 9 import data from the hub. I was focusing on 'run process' but failed to realise that we are not providing any instructions to say where the data goes? If the data is pulled from the Data Hub model to the Supply chain model at what point do you say that the Data should be stored in DAT03 Historic Volumes Module (In the supply chain model)?