Hi,
I'm not sure how to make my Line Items into inputs(blue). They do not have formulas in them so not sure why they are not allowing me to make them inputs. Please advise.
Thank you
Pic attached
@neg177
That may be due to switchover date in Versions. Anaplan will not allow you to make changes to the dates which are prior to the switchover date.
Hope that helps
Misbah
Adding to @Misbah comment. Could also be you don't have write access. Is selective access turned on?
This is why it was doing so. Thank you
It was the Versions issue. Thank you so much for your support.
Why are non‑admin users unable to view Module information on the Anaplan page, while workspace administrators can? (After click the three dots on the grids right up corner) Are there any configuration options that allow non‑admin users to view module details without granting full workspace administrator access?
Just like the main question above, I wanted to try out the new feature on the board where you can you the insights panel to put additional cards. However, I wanted to synchronize scroll a card on the main board with the card on the insights panel but I can't find where it might be.
Hi everyone, I am trying to create a connection ADO from PostgreSQL, but I consistently receive the following error: Failed to establish a connection The following message was sent from the target system: The SSL certificate is either invalid or not in unencrypted PEM format. Please check your certificate and try again.…
