Am migrating our Anaplan Connect batch files from 126.96.36.199 to 1.4 and all is going well except that when it comes to running an import routine it fails because the first column of data in the upload file is titled "crazy character"name rather than just name.
Is this a glitch or something else? Works fine with the original batch file.
There are a few subtle differences in behaviour between 1.3 and 1.4. 1.4 tries to guess the column separator (comma or tab) by looking at the first line, with a bias towards commas. Also, if using "-putc" instead of "-put" then it might not override the encoding but still uses UTF-8 to write the content. If you can identify what the "crazy character" is (eg tab, byte order mark) that might help identify the root cause.
I've seen similar behaviour with file encoding before. When you first uploaded this file, did you leave the default value for the encoding and then change it afterward, or did you select UTF-16LE straight away?
Previously, when I've seen this, it was because the encoding was changed after uploading the file. Could you try deleting the file, and re-uploading being sure to select UTF-16LE as the file encoding? If it persists, you can raise this with our support team to determine the cause of the behaviour.
Thanks, Jesse Wilson Solution Architect - Data Integration
Jesse Wilson Solution Architect - Data Integrations Singapore
Can you confirm whether you're using -put, -puts or -putc to upload a file or -jdbcproperties to pull from a JDBC source? For -put and -puts, Anaplan Connect doesn't modify any content. And a UTF16 encoding on the server side should strip out any byte order mark prefix, so I don't think its that.