Hi all,
i have some issue related to import csv file into the module DAT01 using the following combination of source vs Target every single value will be ignored but i don't know why
i hope you can help me
Thanks!
Andrea
Hi @andrealin ,
You’ll need to check your G3 Location list — it’s likely that the relevant subset hasn’t been assigned any members. You'll have to populate the same before uploading this beginning inventory.
Hi @andrealin, Please check the import mapping settings, for the Line Items 'DAT01 Beginning Inventory line item'. If the line item is set to Ignored, you'll need to manually map it to the correct target line item during the import setup. That should resolve the issue.
Hope this helps.
Hi @Prajjwal88
it s all mapped except for Location Flat: Distribution Centre? i can't see anything for that
Why are non‑admin users unable to view Module information on the Anaplan page, while workspace administrators can? (After click the three dots on the grids right up corner) Are there any configuration options that allow non‑admin users to view module details without granting full workspace administrator access?
Just like the main question above, I wanted to try out the new feature on the board where you can you the insights panel to put additional cards. However, I wanted to synchronize scroll a card on the main board with the card on the insights panel but I can't find where it might be.
Hi everyone, I am trying to create a connection ADO from PostgreSQL, but I consistently receive the following error: Failed to establish a connection The following message was sent from the target system: The SSL certificate is either invalid or not in unencrypted PEM format. Please check your certificate and try again.…
