basically this is a transactional list wherein attributes are from A to E column. Need to create a hierarchy from A to E then convert these column to time .
Hi @AmruthaB
If you set the time period format to the below that should work or at least did in the quick test I did.
Not 100% sure but this feels like something has changed as importing as column headers always used to be quite tricky.
Andrew
Basically, the list will loaded with the combination of properties, then there will be no column(like list mappings) to map time. so I am missing out in the staging phase.
@andrewtye
@AmruthaB
For performance reasons, you should not load any list using combination of properties, especially a transactional list where the list tends to have many members. Why? Before each member gets to loaded, the Anaplan has read the entire list to see if that combination has already been loaded. Also, having time and/or transactional data as part of the list as a property is very poor architecture. Please review this article explaining the reason why.
Why are non‑admin users unable to view Module information on the Anaplan page, while workspace administrators can? (After click the three dots on the grids right up corner) Are there any configuration options that allow non‑admin users to view module details without granting full workspace administrator access?
Just like the main question above, I wanted to try out the new feature on the board where you can you the insights panel to put additional cards. However, I wanted to synchronize scroll a card on the main board with the card on the insights panel but I can't find where it might be.
Hi everyone, I am trying to create a connection ADO from PostgreSQL, but I consistently receive the following error: Failed to establish a connection The following message was sent from the target system: The SSL certificate is either invalid or not in unencrypted PEM format. Please check your certificate and try again.…
