Hi All,
Is there a way to disable switch over in blueprint view for a line item without a time dimension?
Thanks
N
@NB
If you don't have a time dimension then Switchover will be auto disabled for that particular line item. There is no other action required on this.And you won't get any option of disabling it.
Thanks,
Misbah
Hi Misbah,
Please see attached screen shot. Switch over appears to be auto enabled.
Naveed
Hi @NB ,
I think that it is showing because of Version you applied to it.
Please go to Version dimension and see if you have assigned switchover to it.
Naushad.
Hi Naushad,
Switch over has not been applied to the version in question.
If I make the version current, a value appears in the line item, else it stays blank.
And the switchover boolean is checked all along.
Since there is no Time Dimension it shouldn't make any difference to you. But if you want to uncheck it anyway
Include Time Dimension in your line item -> Uncheck the boolean -> Remove the Time Dimension.
Hi @NB
Oh My Bad, As @Misbah Suggested. Please find the below screenshots.
Naushad
Hi, I was hoping to get some help with this situation, where I am trying to take a list to list mapping on the left and get an output similar to the right, but the main idea is i want to be able to make the selected item (format: list), the dimension of a target module and reverse map the original source list as a list…
Hello everyone, I hope you're doing well. I'm posting because two of my coworkers are trying to use the Anaplan Excel Add-In Series 4, but they're running into an issue during the connection setup process. When they go to New → New Read-Only Connection (or New Connection) and reach the "Select a Customer" step, no…
Why in my model output is blank, after send explainability data.
