Referenced by feature for DCA Driver Line items

Referenced by feature for DCA Driver Line items

When you choose a line item as read or write access driver, there's no way to know that the line item is actually being used besides knowing/searching for it as an active driver in line item information.

 

Can we have a 'referenced by' feature for when a line item is an active driver?

6 Comments
Miran
Super Contributor
 
Status changed to: Your support is needed
adam_bimson_5
Contributor

Massive support for this.  All us model builders are always on the lookout for modules/line items which we can delete.  This would help loads.

Gwen.pryor
Regular Contributor
 
Status changed to: Under Investigation
Kristina_Mihay
Contributor

Hello,

 

Are you aware if this is part/planned in the near-future AN enhancement list? This is really important & useful for any AN developer!

 

Best regards

Kristina

KirillKuznetsov
Certified Master Anaplanner

Hi,

 

I also counting on this feature. 

For now you can use workaround: download full list of line items to get this info. Although, it is not as convenient as line items "referenced by"

 

Kirill

shabbiraa
Contributor

@Miran In addition to the above request, I also believe it would be super helpful if there are below indications as well in blue print view

  1. if a line item is being used as a filter
  2. if a line item is being imported into another module/model

 

Needless to say, these indications will ONLY PREVENT deleting line items accidently.