Hi All - Is there a way to suppress zero values from displaying on a NUX line graph? Thanks!
Go to the source and in the format -> blueprint -> select blank when zero in the format.Hope this helps.Mark it as Solved if this works.
Thank you! This approach removes the data label but the chart still plots the zeros. I'm looking for a way to stop the zeros from being plotted if that's possible.
@JessicaD is this what you are looking for?Hope this was helpfulAnurag
The only way to do this from the UX only is to turn off the plotting of trailing zeros (suggested by @Anurag0911). However, this does not help you with any other zero values.
Expanding a bit on the suggestion by @ankit_cheeni to filter out zeros from the chart, you can actually "trick" Anaplan to avoid plotting a zero value by replacing your 0's with NaN's. While you can't manually enter NaN into a line item, you can write a formula that will return NaN. I suggest adding a NaN value to a System constants module so you can use it across your model as needed.
One example of a formula to generate a NaN:
DIVIDE(0,0)
See below post for mocked up example.
Additional resources/credits:
Expanding my above message with a mocked up example.
Constants module with a NaN value:
Data module with values:
System module with logic to check for zeros:
Additional line item showing NaN values in place of zeros:
Final output in the UX (comparing the two line items):
Brilliant! This worked perfectly! My graph no longer plots the zeros but rather starts from the first data point. Thank you for this solution!
Thank you @Anurag0911 This solution works if the zeros are at the end. In my use case, the zeros were in the beginning. This is really helpful though for graphs with trailing zeros.
FYI I have documented the steps in this solution in a How To article: https://community.anaplan.com/t5/How-To/Suppressing-zeros-in-line-charts/ta-p/143610
I love how creative the community members are. This is great, thank you for this.
Incredible solution. Very nice work!
Hi, I was hoping to get some help with this situation, where I am trying to take a list to list mapping on the left and get an output similar to the right, but the main idea is i want to be able to make the selected item (format: list), the dimension of a target module and reverse map the original source list as a list…
Hello everyone, I hope you're doing well. I'm posting because two of my coworkers are trying to use the Anaplan Excel Add-In Series 4, but they're running into an issue during the connection setup process. When they go to New → New Read-Only Connection (or New Connection) and reach the "Select a Customer" step, no…
Why in my model output is blank, after send explainability data.
