Hi,
Need to know how to set up an Admin Account in Anaplan with a email address. Would I be able to do this a a Model Builder, or would the main admin administrator have to do this?
Thank you
Hi @neg177 ,
The person setting up the integration email "service account" needs to be a workspace administrator, but no tenant level set-up is inherently required just to create it.
HOWEVER, there are complexities around implementing this securely -- one of which is that the integration account cannot be set to SSO, and therefore it will either end up needing to pass a plain text password (bad) or will need a CA security certificate, which will end up needing some assistance from your tenant administrator as well as others in your IT organization to procure and configure the certificate for use.
The details on what's actually required and how to implement it will depend on what kind of integrations you intend to implement -- So, I recommend some research around CA Certificates and how they would be used within the integration solution you're going to implement. Here are a couple of links to CA Cert materials:
Interactive CA Certificate Guide - Anaplan Community
Security certificates - Anaplan Technical Documentation
Good luck!
Stacey
Why are non‑admin users unable to view Module information on the Anaplan page, while workspace administrators can? (After click the three dots on the grids right up corner) Are there any configuration options that allow non‑admin users to view module details without granting full workspace administrator access?
Just like the main question above, I wanted to try out the new feature on the board where you can you the insights panel to put additional cards. However, I wanted to synchronize scroll a card on the main board with the card on the insights panel but I can't find where it might be.
Hi everyone, I am trying to create a connection ADO from PostgreSQL, but I consistently receive the following error: Failed to establish a connection The following message was sent from the target system: The SSL certificate is either invalid or not in unencrypted PEM format. Please check your certificate and try again.…
