Hello,
I created a saved view from the actual module and created a UX page for Account Review. In the Module "Country" and "Segment" are subsidiary. I can't figure out how can I use them as a page selector in UX page. Please advise.
Thanks,
Hi @Gharbali,
You can create user filters and use them as dropdown selectors.
Your user filter selection module should look like this, just a simple module with list-dimensioned line items without any formulas.
In the SYS11 User Filter Selection module, line items like "Account Review - Country" and "Account Review - Segment" are published on the UX page.
As shown above, the SYS11 User Filter Selection module is referenced by other SYS modules that contain the actual user filters. There is also a lesson in the Level 3 training on how to set up user filters.
Good luck with the training!
Seyma π·π
Since Country & Segment are not the dimensions of this module and present as a line item, hence we cannot directly use them as page selectors. Instead we need to create filter like Seyma mentioned above.
Hi, I have a form action button that adds a L5 list item to a hierarchy. L5 does not have selective access but L4 does, but I still see all L4 list items in the dropdown when I trigger the form. How can I only view the ones I should have selective access to? L5 does not have selective access. L4 is also a selector on thisβ¦
We are currently experiencing an issue with the behavior when grid Auto Refresh is disabled. For our use case, it is important that the configured formatting is reflected before any manual refresh is performed. Therefore, we have enabled βUse Embedded Workbook Formatting (Preview)β as a workaround to have the formattingβ¦
For auditing purpose I need RTO and RPO details. Could you please share the details and also along with the source URL.
