How to synchronize selective changes from Development model to Production model using "Revision Tag"

UmeshJethwani
New Contributor

How to synchronize selective changes from Development model to Production model using "Revision Tag"

Dear experts,

 

I'm trying to transport/synchronize selective changes from Development model to Production model.
To handle this, I have captured the changes which are not useful into a dummy revision tag.

In another revision tag, I have captured the useful structural changes.

 

However, when I try to synchronize the Production model with Development model, system shows me all the changes together (useful and non-useful) which were captured in above mentioned two revision tag.

I understand that this is because revision tag is a snapshot of the model at the time of its creation.

 

Is there a way to do synchronization of the selective changes?

 

Any input will be highly appreciated.

 

Best regards,

Umesh Jethwani

1 ACCEPTED SOLUTION

Accepted Solutions
parmod.kumar2
Contributor

Hello Umesh,

Use have to use two revision tag process.

 

Please follow the below link

https://community.anaplan.com/t5/Best-Practices/Save-Incomplete-Changes-when-Synchronizing-in-ALM/ta...

 

 

Regards,

Parmod Garg

View solution in original post

2 REPLIES 2
parmod.kumar2
Contributor

Hello Umesh,

Use have to use two revision tag process.

 

Please follow the below link

https://community.anaplan.com/t5/Best-Practices/Save-Incomplete-Changes-when-Synchronizing-in-ALM/ta...

 

 

Regards,

Parmod Garg

rob_marshall
Moderator

@UmeshJethwani 

 

To answer your question, no, you can not do selective sync's as the revision is a snapshot of the entire model at that point in time.  With that said, it is all about what is actually in the revision, which is why Back to the Future works as @parmod.kumar2 stated.

 

Rob